Product Line
P2U Power Extractor/ Splitter
This unique power extractor module can deliver regulated DC power for any secondary device that is not PoE capable. It will allow standard PoE voltage to run over a single CAT5/6 cable to power non-PoE IP device. This product uses standard PoE switches, cables and RJ45 connectors and delivers regulated DC output at a user-selected level of 5V, 9V, 12V or 24V, and also passes 10/100 base- T Ethernet connection through to the output jack. Keep Alive™ circuit provides minimum load to keep the PoE source connected under no-load conditions.
This IEEE 802.11af (Class 0) compatible CAT5/6 power extractor module is designed to work with non-PoE IP connected devices. The output voltage can be selected to go on the unused pairs of the RJ-45 output connector or a 2-pin screw terminal.
Specifications:
DC Input: 48V DC from PoE switch
Output: 5V, 9V, 12V or 24V DC field selectable
Pin Layout: Pin 4 & 5 for power (+), Pin 7 & 8 for ground (-)
LED indicator: Green LED for power
Smart Keep-Alive Circuit ™
Operating Temp: -40 °C to + 70 °C
RoHS Compliant
Built and tested in an ISO 9001:2008 Facility
Dimensions: 3.66” L x 1.50” W x 0.8” H
P2U Data Sheet.pdf
__________________________________________________________________________
P2U-S Door Strike
This unique power extractor module can deliver regulated DC power for electric strikes and magnetic locks. It will allow standard PoE voltage run over single CAT5/6 cable to power the lock. This product uses standard PoE switches, cables and RJ45 connectors and delivers regulated DC output at user-selectable 12VDC or 24VDC. Smart Keep-Alive™ circuit switches on minimum load keep the PoE source connected under no-load conditions. Under continuous duty operation, the output voltage is reduced by 25% to extend the life of the electric strike. This occurs automatically after 10 seconds of continuous load.
This IEEE 802.11af (Class 0) compatible CAT5/6 power extractor module is designed to work with and supply power to non-POE IP connected devices. The power rating is limited by the port rating of the PoE switch or the chart below, whichever is less.
Specifications:
DC input: 48 V DC from PoE switch
Output: 12 or 24V DC, field selectable
Max Current: see chart
Pin Layout: Pin 4 & 5 for power (+), Pin 7 & 8 for ground (-)
LED indicator: Green LED for power
Smart Keep-Alive Circuit ™
Operating Temp: -40 °C to + 70 °C
RoHS compliant
Built and tested in a ISO 9001:2000 certified Facility
Dimensions: 3.66” L x 1.50” W x 0.8” H
NOTE: This CAT5/6 power extractor module is designed to work with 802.3af complaint Ethernet switch products and not with 802.3af end devices. Caution is required when installing this device and installer must have full knowledge of Ethernet and legacy power connections.
|
|
|
|
|
|
|
|
|